Beacon Lighting LUCCI AIRFUSION PEREGRINE Manual De Instrucciones página 9

Airfusion Peregrine Installation Instructions
BATTERY REPLACEMENT FOR THE REMOTE TRANSMITTER
1. To replace a new battery, Press the top of the battery compartment cover and loosen the screw in the same time
further to remove the battery compartment cover (Fig. 15 b).
Note: Screw does not come apart from the battery compartment cover. Do not force the screw and battery
compartment cover apart.
Slide to remove the battery compartment cover from the back of the remote, to access the battery (Fig. 15b)
2.
3. Install a new 3V CR2032 DC battery in the compartment. Please make sure the polarity of the battery is
correct. (Fig. 15c)
Please make sure the polarity of
the battery is correct.
4. Install the battery compartment cover back onto the remote and secure by re-tightening the screw.
PAIRING REMOTE & RECEIVER – WHEN 1 DC CEILING FAN IS INSTALLED IN ONE LOCATION
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for the fan.
NOTE: Ensure power to the receiver is ON prior to pairing the remote with the receiver.
•
Turn OFF the mains supply to the fan by on/off wall switch.
5. Install the battery into the remote. Please make sure the polarity of the battery is correct. (Fig. 15c)
•
Turn ON the power to the receiver.
•
Press and hold the "
ON to the receiver of the ceiling fan.
If the fan has light kit attached, the light will flash on and off to indicate the paring process is activated.
8 | P a g e
Fig. 15b
" button on the remote for 3-5 seconds within 30 seconds of switching the power
Fig. 15c