Troubleshooting Guide - aarke CARBONATOR PRO Manual Del Usuario

Troubleshooting guide

Problem
1. When I push the
Carbonator button, very
little or no gas comes out.
2. Gas is flowing into the
bottle when I push the
Carbonator button,
but the water isn't
carbonated.
3. I hear a leaking sound
when I push the
Carbonator button and
very little gas is flowing
into the bottle.
4. The cover is hard to push
down.
5. The gas cylinder is
freezing inside the machine
during use.
6. Water appears in the drip
tray after carbonating with
a new gas cylinder.
7. The cover doesn't fasten
in the base when I press it.
If the suggested solutions above is not working
contact us at [email protected]
Solutions
• Make sure you're pushing the Carbonator button all the way down
(without forcing it).
• Try screwing the gas cylinder in a bit tighter and try again
(some older cylinders need a little extra tightening).
• Listen for a leaking sound when you push the Carbonator button –
if you hear one, refer to problem #3.
• Check to see if the gas cylinder is empty.
• Make sure you're pressing the Carbonator button until you hear a
buzzing sound, then release. Be sure to not release until you hear
the buzzing sound!
• Try screwing the cylinder in a bit tighter.
• There may be an issue with the cylinder gasket. See "Cylinder
gasket troubleshooting".
• Try to press further back on the cover.
• There may be a leak between the cylinder and the machine.
Try screwing the gas cylinder in a bit tighter. If it doesn't work, see
"Cylinder gasket troubleshooting".
• Water in the drip tray is normal. However be sure to not fill the
bottle over the filling line. Wipe away excess water with a sponge.
• Try pressing harder on the cover.
11
EN