Making Coffee - Brasilia MAKI Instrucciones Para El Uso

MAKING COFFEE

• Open the capsule-holder compartment (4 Fig.
l) by raising the lever (5 Fig. 5).
• Place a capsule (13 Fig. 5) in the capsule
holder (4 Fig. 5).
• Lower the lever (5 Fig. 5) to "C".
• Wait the reaching of water temperature
signalled by the switching-on of warning
light.
• Place a cup on the grid (7 Fig.4) and press the
switch (9 Fig. 1) to "ON" to start dispensing
coffee. When the desired amount has been
obtained press the switch (9 Fig. 1) to "OFF"
to stop dispensing.
• When dispensing is finished, if you want to
dispense more raise the handle (5 Fig. 5) to
"A", the capsule is automatically unloaded into
the drawer (6 Fig. 4).
N.B.: After dispensing coffee always leave the
capsule-holder compartment (4 Fig.5) open,
lever (5 Fig.4) in position "C".
The capsule drawer (6 Fig. 6) can hold
a maximum of 10 capsules, after which
it absolutely most be emptied, pulling it
outwards.
It is advisable to empty the capsules from
the drawer (6 Fig. 1) after making 5-6
coffees.
CLEANING
Before doing any cleaning, ALWAYS
disconnect the plug (8 Fig, 1) from the
power socket.
• Use a damp cloth to clean the body of the
machine (1 Fig. 1) and do not use abrasive
detergents.
Never immerse the machine body (1
Fig.1) in water or other liquids.
Never wash any machine component in
the dishwasher.
English
18
All manuals and user guides at all-guides.com
• Remove the grid (7 Fig. 1) and the basin (6 Fig.
• Periodically remove the water tank (2 Fig. 3)
DESCALING
• Descale the machine periodically.
• Pour a measure of descaling liquid into the
• Make sure that there is no capsule in the
• Lower the lever (5 Fig. 1).
• Start the machine as explained in the section
• Place a vessel with a capacity of about 500 cc
• Dispense hot water 3-4 times by pressing
1), empty any capsules and wash them with an
ordinary dishwashing detergent.
and rinse it with clean water then put it back
properly in its place.
The frequency of this operation depends
on the hardness of the water used.
tank (2 Fig. 1) (follow the manufacturer's
instructions).
Only use solutions suited for espresso
coffee machines.
capsule-holder compartment (4 Fig. 1)
"Starting up the machine".
on the grid (7 Fig. 1).
button (9 Fig. 1).
After doing this, repeat the operations
escribed above, using clean water only,
to remove residues of the solution from the
circuit. Rinse the tank (2 Fig. 1) well and dry it
before using the machine again.