Error Codes - Steelcase Slim Leg Guia Del Usuario

Active Touch Controller
RESETTING THE ACTIVE TOUCH DISPLAY HEIGHT
• Press 1, 2, 1, 2. The text will begin blinking "SELECT", "HEIGHT".
• Lift
up or press down
• Once the correct height has been chosen, pause for 2 seconds.
• The light guide will fill. When all three bars are full, the starting height is saved.
ADJUSTING THE HEIGHT DISPLAYED
• It may be necessary to adjust the height displayed, which is set to the default
setting from the factory.
• Press and hold the 1,
• The display will flash "ADJUST HEIGHT", and then the current desk height
will flash on the display.
• Lift
or press
up down
The new desk height will flash until the light guide fills.
not move during this step.
SWITCH DISPLAY FROM INCHES TO CENTIMETERS
• Press and hold the
1
change the display from "INCH" to "CM". The new selection will flash until the
light guide fills.

ERROR CODES

• In the event of a fault, the display may show an error code number and brief
description.
on the controller to scroll through the starting height options.
2 and buttons simultaneously for four seconds.
on the controller to change the height displayed.
and buttons simultaneously for three seconds, to
The desk should
TIP: