OPERATING AND MAINTENANCE MANUAL
SUBMERSIBLE HYDRAULICS IX SERIES
1. INSTRUCTIONS FOR USE
ENG
These submersible hydraulics are particularly designed for clean water.
Their use is subject to the directives of local legislation.
Before installation and use, please read the instructions.
The manufacturer declines all responsibility in the event of any incident or damage due to negligence
or non-observance of the instructions described in this booklet or the conditions indicated on the
nameplate.
on the nameplate. It also declines any responsibility for damage caused due to improper use of the
submersible pump.
2. IMPORTANT
Before carrying out any control or maintenance operation, disconnect the power supply to the system.
Before installation, make sure that the mains supply is earthed and complies with the regulations.
These pumps are not suitable and must not be used for the transfer of flammable liquids or for opera-
tion in explosive atmospheres.
Avoid any contact between the supply voltage and the liquid to be pumped. Do not modify the electri-
cal components of the electric pump.
Under no circumstances should the electric pump be supported, transported or lifted by the power
supply cable.
3. PRELIMINARY INSPECTIONS
Remove the contents of the package and check the contents. Also check that the information on the
nameplate corresponds to the requirements of the installation. In the event of any anomaly, contact
Proindecsa immediately, indicating the nature of the defect.
CAUTION:
If in doubt about whether or not the pump is indicated, do not use it.
4. CONDITIONS OF USE
Submersible hydraulics must be used under the following conditions:
•
•
•
•
Maximum liquid temperature: 30ºC
Admitted voltage variation: 5%.
Degree of protection: IP68
For special executions the water temperature can reach up to 50°C.
10