Connecting To The Board With Spinet; Troubleshooting - FAAC XKPR125 Manual Del Usuario

4. CONNECTING TO THE BOARD WITH SPINET

- Connect the Spinet Bus to terminal J1 as indicated in  2.
!
For each device connected to the SPINet line, position the address Pins so that the same address
is used on only one device.

5. TROUBLESHOOTING

Indication
The XKPR gives an error when it is
switched on.
No LEDs (Red or Green) are activa-
ted when a code is entered.
The device does not turn on.
An enabled user code or the tran-
sponder has not been validated,
the red LED lights up.
MAINTENANCE
Clean the outer surfaces only with a soft cloth Do not use detergents or oils. Do not make any modifications
to the original components. Only use original FAAC spare parts.
XKPR
Explanation
There are two readers with the
same address.
The keypad is disabled.
No power or device not working. Check that the power supply is
Software configuration error.
15
Translation of the original instructions
Necessary action
Change the address for one of the
two devices.
Check the keypad configuration of
the Device in the Keydom software.
connected and live. If there are no
errors, replace the device.
Check the Access Media configura-
tion in Keydom.
EN
532192 - Rev.D