Connect Hoses And Water Supply - Craftsman 580.752850 Manual Del Operador

Connect Hoses and Water Supply

NOTICE Use ONLY cold water (less than 100°F).
1. Attach garden hose (50 ft. / 15.24 m maximum) to water
supply.
2. Run water through garden hose for 30 seconds to fl ush
the hose of debris. Turn off water.
3. Confi rm that water inlet screen (A) is installed in water
inlet located at lower front of unit; Do Not remove except
for cleaning.
C
A
B
NOTICE If inlet screen is damaged or missing, DO NOT
use electric pressure washer. Call 1-800-222-3136 for
assistance.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow
this instruction will void warranty.
4. Attach opposite end of garden hose (B) to the water inlet
coupling (C). Tighten by hand.
5. Completely remove the high pressure hose from hose
reel. Attach high pressure hose (D) to the unit's water
outlet (E) located at lower back of unit. Tighten by hand.
D E
6. Attach opposite end of high pressure hose to the spray
gun. Press red button (F) on spray gun, then insert end
of high pressure hose (G) into gun until it SNAPS into
place. Release the red button and make sure connection
is secure.
F
G
Connect Wand
1. Turn ON water, point gun in a safe direction, press trigger
release (H), then squeeze trigger (J) to purge pump
system and spray gun of air and impurities.
2. Insert and twist desired wand (K) into spray gun (M).
Once wand slides into gun, apply further inward pressure
to wand and twist 1/4 turn clockwise until securely in
place.
K
3. Turn OFF water and release trigger. Point gun in a safe
direction and make sure trigger cannot be squeezed.
Connect Foam Lance
1. Insert the adjustable fan jet wand (N) into spray gun (P).
Once wand slides into gun, apply further inward pressure
to wand and twist 1/4 turn clockwise until securely in
place.
N
10
H
J
M
P