Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
DESCRIPTION
- Antenna splitter for 4 UHF wireless system receivers.
- It improves the antenna signal reception if the receivers are in racks.
- It uses 2 front antennas to distribute the antenna signal to 4 receivers.
CONTROLS AND FUNCTIONS
FRONT PANEL
ANTENNA A/ANTENNA B: LED signal status and A and B input signal amplification indicators.
1.-
- BOOSTER: indicates 8 V signal presence in the output of antennas A or B.
- CALIBRATE FAIL: indicates that it is necessary to calibrate the connected amplifier or that it is
not possible to calibrate it due to losses produced in the cable.
- CALIBRATE PASS: indicates the correct calibration of the amplifiers connected in the antenna
output A or B.
CALIBRATE: this button is used to automatically calibrate the gain of the amplifiers connected in the
2.-
antenna output A and B to compensate for the losses produced by the wiring.
POWER: splitter on/off switch.
3.-
4.-
Holes for installation of antennas A and B.
REAR PANEL
ANT B IN: antenna B microphone signal input, TNC connector.
1.-
RF OUT B: microphone signal output for its distribution to the microphone receivers, TNC connector.
2.-
3.-
12 V, 450 mA power supply.
RF OUT A: microphone signal output for its distribution to the microphone receivers, TNC connector.
4.-
ANT A IN: antenna A microphone signal input, TNC connector.
5.-
- 2 -
Tabla de contenido
