Fuel System; Engine Oil - Snapper RPX200 Manual Del Operario

Storage
WARNING
Never store the unit (with fuel) in an enclosed,
unventilated structure. Fuel vapors can travel to an
ignition source (such as a furnace, water heater, etc.) and
cause an explosion. Fuel vapor is also toxic to humans
and animals.
When Storing Fuel Or Equipment With Fuel in Tank
• Store away from furnaces, stoves, water heaters, or
other appliances that have pilot lights or other ignition
sources because they can ignite fuel vapors.
Equipment
Disengage the PTO, set the parking brake, and remove the
key.
Battery life will be increased if it is removed. Put in a cool,
dry place and keep fully charged during storage. If the
battery is left in the unit, disconnect the negative cable.

Fuel System

Fuel can become stale when stored over 30 days. Stale fuel
causes acid and gum deposits to form in the fuel system
or on essential carburetor parts. To keep fuel fresh, use
Briggs & Stratton® Advanced Formula Fuel Treatment
& Stabilizer, available wherever Briggs & Stratton genuine
service parts are sold.
There is no need to drain gasoline from the engine if a
fuel stabilizer is added according to instructions. Run the
engine for 2 minutes to circulate the stabilizer throughout
the fuel system before storage. If gasoline in the engine has
not been treated with a fuel stabilizer, it must be drained
into an approved container. Run the engine until it stops
from lack of fuel. The use of a fuel stabilizer in the storage
container is recommended to maintain freshness.

Engine Oil

While the engine is still warm, change the engine oil. See
Changing the Oil section.
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Perform all recommended checks and procedures
found in this manual.
• Allow the engine to warm up for several minutes before
use.
All manuals and user guides at all-guides.com
23
en