Idiomas disponibles
Idiomas disponibles
Do NOT over-reach while operating this tool. Loss of balance can cause
serious personal injury or death. Move closer to work area and securely
support yourself and your work. ALWAYS keep proper footing and
balance.
Use all appropriate personal safety equipment when handling, operating, and
servicing this tool such as: safety shoes, hard hat, eye and ear protection, work
gloves, and sleeves.
Safety is everyone's responsibility.
2. INTRODUCTION
The MY2913GE2 hand operated crimping tool delivers 40kN of force, and both MY70M and MY70ME
delivers a force of 28 kN. All of these crimping tools are provided with an adjustable die, depending on
the section of the cable to compress, by a fixed scale at the body of the tool.
The crimping process is hand operated in all tools: MY2913GE2, MY70M and MY70ME.
2.1 Characteristics
Hand operated crimping operation
Adjustable die by a screw with fixed steps and a fixed scale at the body of the tool
User friendly and tough.
MY2913GE2 y MY70M
o For crimping non insulated copper terminals and splices
MY70ME
o For crimping insulated copper terminals and splices
2.2 Description
Note: The following example corresponds to the MY2913GE2 tool, but is also valid for the MY70ME and MY70M
tools. (See last page)
3. OPERATING
3.1 Adjusting the opening for crimping terminals
Turn the fixed steps screw for vertically displacing of the upper die. Turn until the level placed on the
upper die reaches the desired level of the fixed scale in the tool body.
3
1.-
Turn the screw of fixed steps in the desired
direction.
1
2.-
The upper die will move upward or downward
(depending on the moving direction of the
screw)
3.-
Once the desired level is reached, stop turning
the screw
2
Level of the upper die
Fixed scale
6
Capítulos
