Working Advice; Maintenance And Service; Maintenance And Cleaning - stayer 384B Manual De Instrucciones

Turning the adjustment sleeve 3 in clockwise di-
rection results in a greater screw-in depth; turn-
ing in anticlockwise direction reduces the screw-
in depth.
The required setting is best determined by test-
ing.

Working Advice

- Apply the power tool to the screw only when
it is switched off. Rotating tool inserts can
slip off.
Guide the screw toward the screwdriving bit 1.
The screw is held in place by the magnet pull of
the universal bit holder 9. Firmly push the tip of
the screw into the material to be screwed until
the screwing-depth stop 4 faces against the
workpiece.
Switch the machine on. The screw is screwed in-
to the material until the adjusted screw-in depth
is reached. The drive is disengaged and the tool
holder no longer rotates. Check the screw-in
depth and readjust, if required.
For unscrewing screws, set the rotational direc-
tion switch 8 to left rotation and pull off the
screwing-depth stop 4 toward the front without
turning the adjustment sleeve.
Working with the screwing-depth stop 4 is also
possible when adapting the screw-in depth.
Belt Clip
With the belt clip 5, the machine can be hung on-
to a belt. The user has both hands free and the
machine is always at hand.
All manuals and user guides at all-guides.com
ENGLISH
10
Disposal
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
Only for EC countries:
power tools that are no longer usable must be
collected separately and disposed of in an envi-
ronmentally correct manner.
10

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
-
the mains plug.
- For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Stayer power tools.
WARNING! Important instructions for connect-
ing a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
Do not dispose of power tools into
household waste!
According the European Guideline
2002/96/EC for Waste Electrical
and Electronic Equipment and its
implementation into national right,