Tabla de contenido
• The device must be installed in such a way that the warning texts are easy to read
after installation.
• The device must not be installed in a wall recess, unless otherwise stated in the
instructions.
• Do not place the supply air vent so that the air flow cools the temperature sensor (see
temperature sensor installation instructions!)
• If the supply cord is damaged, it must be replaced by the manufacturers' service person
or a similarly qualified person in order to avoid a hazard.
• Use of a PVC-insulated cable as a connection cable for the heater is prohibited due to
its thermal fragility.
• Do not connect power supply to electric heater via a residual current device.
• If device is connected to water supply, there must be a floor drain on the floor of the
sauna room and/or washroom in case of hose breaks or leaks.
• If device is used in public saunas without a timer, the indicator light, which tells if the
device is on, must be placed in the room where the device is controlled.
INSTRUCTIONS FOR USE AND BATHING
Always check that there are no objects on the heater or near the heater before
switching it on.
Beware of hot heater. The stones and metal parts of the heater may burn the
skin.
Do not cover!
• Sea air and a humid climate may corrode the metal surfaces of the device.
• Do not hang clothes to dry in the sauna, as this may cause a risk of fire. Excessive moisture
content may also cause damage to the electrical equipment.
• Do not press the overheating protection button before the cause of the fault has
been found. Only persons authorised to carry out electrical installations can reset the
overheat protector, unless otherwise stated in the instructions manual.
• Always check that the heater has switched off and stopped heating after the on-time
period has elapsed.
• In public saunas, where the heater is used without a timer or continuously for longer
than the timer of the heater or the control unit allows with the factory settings, the
device must be constantly supervised.
• The sauna room and surroundings of the heater must always be checked before the
heater is switched on again or it is switched on with the remote-control system.
• The sauna room and surroundings of the heater must always be checked before
the device is brought into standby mode required by remote control or pre-timed
operation.
• According to the product standard IEC/EN 60335 -2-53 regulating electrical sauna
heaters, the control unit can be used to remotely control the heater once the heater or
sauna room door is equipped with a secure switch (safety or door switch).
7
Tabla de contenido
