Electrical Safety - Naterial NORI 2 Instrucciones De Montaje, Utilización Y Mantenimiento

appropriate tools, sufficient operators (3 persons are suggested) and space, and a clean and
FR
dry area to perform the installation.
Switch the power off before cable installation.
ES
Before installing the product, remove the unnecessary cord and disable any equipment not
needed for power operation.
PT
Choosing a safe location
IT
Never install it in high and windy places, as the sunshade may drop and hurt people. The
location for mounting your automation device: this location must allow for the automation
EL
device to pick up the signals easily to ensure maximum sensitivity of the command box.
Do not use it in places that have vibrations or impulsions.
PL
In case of use of a command box, the electronics board must be set vertically and sheltered
from the weather.
UA
The installation can be made by non-professionals assuming the instruction is followed
correctly. Should you have any trouble during assembly, please consult a qualified person for
RO
help.
Please use all the screws and nuts correctly during installation as it is very dangerous if you
EN
leave it loose.
Be careful with your fingers around moving parts of the product during installation.

3. ELECTRICAL SAFETY

CAUTION: The installation must be conform to the regulation of the country.For your safety,
please make sure that the electric current is switched off before carrying out any setup or
connection operation.
Before connecting the appliance to the power supply, check that the power supply voltage and
current rating corresponds with the power supply details shown on the appliance rating label.
A readily accessible disconnect device must be incorporated in the fixed wiring in compliance
with setup regulations.
Danger of electric shock! Do not attempt to repair the appliance yourself. In case of
malfunction, repairs are to be conducted by qualified personnel only.
The modification of the design or configuration of the equipment without consulting the
manufacturer or his authorized representative may create a dangerous situation.
The power cable for this motor can only be replaced with the same type of cable supplied by
What you will need: hardware not provided:
> Waterproof junction box (P54)
BATTERIES
> Cables > (CR2450 3V)x 1
78