Lumatek CONTROL PANEL PLUS 2.0 Manual Del Usuario página 6

For LED:
1. Mount the fixtures as per your lighting plan. Interconnect them as
described in the manual for the fixture, using the LED control cable
supplied with the controller and a control link cable purchased separately
for each additional fixture to be daisy-chain connected in series.
Using LED control link cable, connect LED fixture 1 'Signal Out' port
2.
(LED fixture 'Frame B') to the 'Signal In' port of LED fixture 2.
Connect LED fixture 2 'Signal Out' port to
3.
the 'Signal In' port on LED fixture 3.
4.
Daisy-chain connect all remaining LED fixtures in series accordingly.
5. Connect the LED fixtures to the mains.
Note! Each of the controller's two channels (Zone A & Zone B) can control up
to 50 LED fixtures. It is possible to use those channels to control LED fixtures in two
separate rooms or to control up to 100 fixtures in one room.
Warning! Each Channel (Zone) can only control same-powered LED fixtures/drivers;
Zone A can control the same-powered LED fixtures as Zone B or Zone B B can be set
to control different powered LED fixtures eg: Zone A can be set to control 600W LED
fixtures and Zone B set to control 465W or 1000W LED fixtures.
CONNECT CONTROLLER
CABLE TO SIGNAL IN