ASSEMBLY INSTRUCTIONS
FRONT VIEW
1. Take out the Infinity Robot.
2. If the surface thickness of your Table tennis
table is 18mm, put the 18mm cap on the pole,
and the number has been marked on the cap.
Note: The thickness of the caps are 6mm, 12mm,
15mm,18mm, 22mm, 25mm.
3. 1 person holds the Robot and stuck the Robot
at the end of the table.
4. Pull the support rod to let the net unfold and
hang the side of the net on the net post.
5. Plug A/C Adapter in the back of
Robot and plug into wall.
YOU ARE NOW READY TO PLAY!
SIDE VIEW
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)
This device may not cause harmful interference, and
(2)
This device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits
set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum
distance 10cm between the radiator & your body.
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.
-English: "
This device complies with Industry Canada
licence-exempt RSS standard( s). Operation is
subject to the following two conditions:
(1)this device may not cause interference, and
(2)this device must accept any interference,
including interference that may cause
undesired operation of the device."
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
-French:"
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée
aux deux conditions suivantes :
(1)l'appareil nedoit pas produire de brouillage,
et
(2)l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre
le fonctionnement."
