Saw Blade - KNOVA KN M-3059R Manual Del Usuario

ASSEMBLY
4. Loosen the bevel lock handle (2), tilt the cutting head
towards the left and then turn the detent block (5)
clockwise 180° to release the positive stop bolt (7). (Fig. B)
5. Pull out the safety lock pin (3) and grasp the switch
handle (4) to lower the cutting head towards the right and
down until the pin (3) locks into place. (Fig. B)
NOTE: Make sure the cutting head is locked in position and
could not be moved.
6. Tighten the bevel lock handle (2). (Fig. A)
WARNING
DO NOT STORE MATERIALS ON TOP OF
SAW when in the folded or unfolded position.
INSTALLING THE DUST BAG (FIG. G)
1. Squeeze the metal collar wings (1) of the dust bag (2).
2. Place the dust bag neck opening around the dust port (3),
and release the metal collar wings (1).
WARNING
Do not use this saw to cut and/or sand
metals. The hot chips or sparks may ignite sawdust
from the bag material.
1
INSTALLING THE HOLD-DOWN CLAMP ASSEMBLY
(FIG. H, I)
WARNING
CUTTING SMALL OR ROUND MATERIAL
It should be cut just like wood and CLAMPED OR
HELD FIRMLY TO THE FENCE TO KEEP IT FROM
ROLLING. This is extremely important when making
angle cuts.
1. Place the hold-down clamp assembly (1) into the mounting
hole (2) located behind the fence. The clamp should be
facing toward the back of the miter saw as shown in Fig. H.
2. The groove on the clamp rod should be fully inserted into
the mounting hole of the base without being visible. If the
groove is visible, the clamp will not be secure.
3. Rotate the hold-down clamp assembly (1) 180 degrees
toward the front of the miter saw.
4. Loosen the knob (3) to adjust the clamp up or down to
firmly clamp the workpiece.
5. The hold-down clamp assembly (1) can be inserted in one
of the two mounting holes (2) located behind the fence on
either side of the base. (Fig. I)
NOTE: Place the clamp on the opposite side of the base when
bevelling. ALWAYS MAKE DRY RUNS (UNPOWERED)
BEFORE FINISH CUTS TO CHECK THE PATH OF THE
BLADE. ENSURE THE CLAMP DOES NOT INTERFERE
WITH THE ACTION OF THE SAW OR GUARDS.
2
Fig. G
3
Fig. H
2

SAW BLADE

NOTE: The miter saw comes with the saw blade already
installed.
WARNING
Make sure the blade is installed correctly
and is tight before operating. See page 12 in
adjustments to tighten or remove the saw blade if
necessary.
SAW BLADE WRENCH STORAGE (FIG. J)
For convenient storage and prevention of loss, there is a
slot (1) in the carrying handle for storing the blade wrench (2)
when not in use.
10
1
2
2
Fig. I
Fig. J
1
2