GYS POWER PACK 520 Manual Del Usuario página 11

Translation of the original instructions
OPERATION OF THE DIFFERENT SUPPLY MODES
Switch on the POWER PACK 520 by pressing the On / Off button (1). The display will light up.
1 / Use of 230 Vac outputs
1. Press button (4) to activate the AC outputs (5), the icon
2. Connect the desired device to one of the AC sockets (5).
3. Press the button (4) again to deactivate the outputs (5).
The total consumption of all devices connected to the POWER PACK 520 must be less than its maximum
capacity of 500 W.
2 / Use of 12 VdC outputs
1. Press button (6) to activate the DC outputs, the icon
2. Connect the desired device to one of the 12V output ports (8) or to the cigarette lighter socket (7).
3. Press button (6) again to deactivate the DC outputs.
3 / Utilisation des sorties USB
1. Press button (9) to activate the USB outputs. Icons
2. Connect the desired device to the corresponding USB port :
(10) USB Type-C
(11) USB Quick Charge 3.0 (5 V / 3 A)
(12) USB (5 V / 3.1 A max)
3. Press button (9) again to deactivate the USB outputs.
To switch off the POWER PACK 520 :
- press and hold down the On / Off button (1) (> 2 s)
- disable all outputs and wait 30 seconds, the POWER PACK 520 will automatically switch to standby.
Interface specifications and voltage standards are not the same in different countries. Before
use, carefully check whether the product specifications are in accordance with the specifica-
tions for use of electrical equipment, otherwise it may lead to dangerous situations.
The POWER PACK has overload protection. If an AC device requires more power than the
nominal power of the POWER PACK 520 (500 W), it will not activate.
USE OF LEDS
1. Switch on the device by pressing the button (1).
2. Press button (14) for a long press (> 2 s). The LED lights up in standard mode. The icon
3. Press button (14). The LED lights up in 'SOS' mode.
4. Press button (14) again. The LED lights up in 'Flash' mode.
5. A further long press (>2 s) switches the LED off.
CHARGING THE POWER PACK 520
When the product is charging normally, the
There are several ways to recharge the POWER PACK 520:
1 / Use the mains charger supplied
1. Plug the charger port (3.5 mm) into the DC 24 V input (3) of the POWER PACK 520.
2. Connect the other end of the charger to a 230 V mains socket.
3. Allow the POWER PACK 520 to recharge and then disconnect it from the power supply by performing the reverse
procedure.
POWER PACK 520
lights up on the LCD screen.
will appear on the LCD screen.
and will appear on the LCD display.
The icon appears on the screen.
The and icons appears on the screen.
and icons blink on the LCD display.
EN
appears on the display.
11