Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To remove the battery 5, press the battery unlocking
button 9 and pull the battery out of the power tool toward
the rear. Do not exert any force.
The battery is equipped with a NTC temperature control
which allows charging only within a temperature range
of between 0º C and 45º C. A long battery service life is
achieved in this manner.
Observe the notes for disposal.
Assembly/Disassembly of the tool (Fig A - D)
For cleaning of the tool or installation of the 310ml
cartridge adapter it will be necessary to disassemble and
then reassemble the bracket (1).
Assembly
1- Insert the bracket (1) into the joint (2) by turning it
clockwise (Fig. A).
2- Insert the push knob (4) into the push rod (3).
3- Insert the push rod (3) through the rear hole of the tool
(Fig. B).
4- Fit the pusher plate on the pusher bar (3 - Fig. C) and
then screw the two parts together (Fig. D).
Disassembly
To disassemble the tool, follow the steps in the previous
section in reverse order.
Installing cartridges
1- Cut off the tip of the nozzle of the cartridge to be
installed so that the material can flow optimally.
2- Screw the nozzle included with your silicone cartridge
onto the tube.
3- With the tool switched off and the battery (8)
disconnected, remove the push rod (3) by pulling the
knob (4) until the rod stops in the joint of the support (2).
4- Insert the cartridge by fitting it into the holder (1), so
that the nozzle protrudes from the front while the back of
the cartridge rests against the seal of the holder (2) and
the push bar (3).
Cartridge holder for 310 ml cartridges.
With the bracket (1) removed, insert the O-ring, gasket
and washer with holes into the bracket gasket (2). Use
the 4 screws to fix the bracket.
3_USE
CONNECTION/DISCONNECTION
Insert the battery (8) after making sure that the battery
has sufficient charge. Insert a silicone cartridge.
To start the power tool, press the safety button (6) and
then simultaneously press and hold the switch (5). To
keep the tool running, keep the switch (5) pressed.
Depending on the pressure exerted on the trigger, a
higher or lower speed of the tool will be achieved.
To switch off the power tool, release the switch (5).
OPERATION
Press the switch (5) to start the silicone feed.
At the beginning of the operation, it is recommended
to start the operation with the speed regulator (7) at
minimum and slowly press the switch (5) to control the
amount of material that is ejected from the cartridge.
Adjust the speed of the tool according to the needs of the
type of silicone you are using, increasing the speed for
less viscous or fast drying materials. It is recommended
to adjust the speed slowly so as not to force the tool.
At the end of the job, release the switch (5). The machine
will continue to eject material for an additional 2 seconds to
prevent dripping, reducing the pressure on the cartridge.
After finishing the job, clean the tool of any remaining
silicone before it dries.
-
11
-
es
it
gb
de
fr
p
tr
cz
el
Tabla de contenido
