Qilive Q.6855 Manual Del Usuario página 26

Error Display
EN
Cause
Water injecting problem
during wash cycle.
Overtime water
draining
Water overflow
Communication error:
The main control board
and display board
cannot communicate
with each other when
the washing machine is
powered on.
Water level sensor
error: The frequency
of the water level
sensor is not within the
specified range
Inverter board
overcurrent
IPM temperature
sampling error on
inverter board
The speed signal from
the inverter board was
lost or blocked
Overtemperature on
inverter board motor
26
Solution
1. Check if the water
pressure is high
enough.
2. Straighten the water
pipe.
3. Clean the inlet valve
filter.
Check the drain hose for
blockage.
Restart the appliance.
1. Check whether the
communication wires
between the main
control board and
the display board are
loose.
2. Check the computer
board.
1. Check the water level
sensor.
2. Check the wiring of
the water level sensor.
3. Inspect the computer
board.
1. Change the inverter
motor board.
1. Change the inverter
motor board.
1. Place the washing
machine at room
temperature for
two hours and then
enable T12 for self-
calibration.
2. Change the computer
board.
1. Place the washing
machine at room
temperature for
two hours and then
enable T12 for self-
calibration.
2. Change the computer
board.