First Use - Jocel TY2608B2 Manual De Instrucciones

FIRST USE

• Take off the protection film or label (if any) on the soleplate and clean it with soft towel before first
using.
• For the power cord is stowed in iron base, please pull out the power cord with proper strength
until you hear a silvery "pa" sound which show the pulled out length of power cord has reached
the length specified in first archive. Loosen your hand at that time, the power cord will fix in this
length. If pull it again and loose your hand at that time, the power cord will be drawn back
automatically. If you need the length setting to the second archive, you can keep on draw it
backward until hear sound "pa" to loosen your hand. The power cord will fix in this length
automatically. If you need the length be longer, just repeat this operation. (Please note that when
the length of wire close to yellow caution mark, it shows that the wire has be the actual usable
longest length, draw it longer will see red caution mark indicating it has reached high-point
length).
• The iron will give out some smoke when first using. It is normal. After a short time, the smoke will
stop.
• Maybe there are little white particle eject from the steam hole of the soleplate when first using. It
is normal.
WAY OF USING
Filling water
1. Open the water inlet cover and fill water into the water tank when appliance is powered off, water
can't exceed the max water level to avoid water overflow, then put on the water inlet cover.
2. When the transparent cover is open, please open the water inlet valve, and use water cup to fill
water into water tank, the max of water can't exceed max water level to avoid water overflow, then
put on the affusion water valve.
Temperature setting
• Firstly check the clothes to see if there is ironing instruction on it, and refer to the following
information to set the suitable temperature.
•
●
If there is no ironing on the clothes, but you don't know the clothes material, you may also refer to
the following information to set the suitable temperature.
•
●
When plug in and the power indicator light turn on, open the transparent cover and rest the iron
correctly on the heat insulation supporting board of the base.
• Turn the temperature control knob to correct position required by cloth material.
•
● When the heat indicator light turn off ,you can begin to iron(from power switch on to heat indicator
light turn off need about 2minutes)