Hortensus HOR-MANTER250 Manual De Usuario página 71

The awning's crank gear has no stop to limit revolutions of the roller tube. To avoid
damage to the fabric, therefore, the awning fabric must always be properly rolled up.
The awnings are intended as a protection against the sun only. It is not to be
used during periods of strong wind, rain, hail, or snow. In case of such conditions,
retract the awning immediately.
Never allow children to play with the awning.
Be sure the fabric is tensioned. If the fabric is not tensioned during extension,
please turn counter-clockwise until the fabric is tensioned.
Do not put any objects or parts of your body e. g. hands, in the awning while
extending and retracting. Hazard of crush!
When the front bar touches the roller as shown in following figure during retraction,
don't try to make them closer, otherwise the product might be damaged
Take out the crank handle from loop after adjusting the awning as you wish
and put it on a place that is not reachable for children to avoid that they play
with the awning.
General notes of the awning fabric
Awning fabrics are high performance products. Nevertheless, even given today's state of the
art and the requirements imposed by environmental protection, there are limits to perfection.
Certain appearances in the fabric that are sometimes objected to are still possible despite
sophisticated production and processing technology.
Basically, these effects occur to different degrees in almost all awning fabrics. They do not
decrease the quality of the fabrics in any way, however.
To avoid irritation, we would like to expressly draw your attention to the following
characteristics in terms of consumer education:
Creases are created during fabrication and when folding the awning fabric. In the
course of this process, especially in lighter colors, surface effects can be created in the
crease (pigment displacements), which appear darker with backlight (like stripe of dirt).
They do not decrease the value or the performance of the awning.
Chalk effects are light stripes that are created when processing refined goods and
cannot be totally avoided even with the greatest of care. Thus, they also do not
constitute a reason for complaint.
Loop
Crank
handle