Hortensus HOR-MANTER250 Manual De Usuario página 70

Once you have achieved the highest possible range of pitch, the loop cannot be
turned any farther. Do not force it! Failure to follow these instructions can damage
the flex pitch shoulder and void the warranty.
Extend the awning no more than 1/4 of its full projection before adjusting.
Drawing 7:
The pitch angle can be adjusted on all arms in the adjusting area (7.1).
Take off the plastic caps, loosen the locking bolts 9 with a 14mm wrench.
Turn the adjusting screw clockwise to decrease the pitch angle; turn counter-clockwise to
increase the pitch angle. When achieved to the desired pitch angle, tighten the safety nuts
and put the plastic caps back on it (7.2).
Follow the same procedure until all arms have been adjusted to the desired level.
The front bar must always be level. To ensure that both sides are completely level,
a built-in level is located on the front bar: the air bubble must be exactly in the middle
of the level.
Place the plastic caps on the screws to protect them against weather based corrosion.
Always remove the crank handle and keep it in a safe and dry place
Extend and retract the awning
The awning can be extended and retracted by a crank handle included in delivery.
Drawing 8:
Insert the handle in the loop that is fixed at the awning. Open the awning by turning the crank
handle clockwise.
By turning it counter-clockwise you can retract the awning.
Adjusting
area
Adjusting
screw
Safety nut
Safety nut