Espressione EM-1040 Manual De Instrucciones página 12

English
Draining and priming of the water circuit
Before using for the first time it is imperative that you allow the water to circulate through all of the
appliance's circuits to remove any possible air and for the pump to be activated.
1. ESPRESSO SIDE
With the water tank full:
Connect the power cord.
Check that the rotating control button is set to PENDING
SELECTION button (h5) is at ESPRESSO/HOT WATER
Check the FILTER COFFEE light (h1) is off and the FILTER COFFEE (h2) button
setting.
Switch the machine on by turning the START/STOP (h7) button to the right to the
The TEMPERATURE light (h6) flashes slowly to indicate that the Thermo block is heating up.
(Approximately 1 minute).
IMPORTANT
While the TEMPERATURE light (h6) flashes, none of the ESPRESSO functions can be used.
Place a large container under the HOT WATER/STEAM spout.
When the TEMPERATURE light (h6) stops flashing, turn the rotating control button to the HOT WATER
(Fig.3) .
function
The pump starts working at a steady rate and the hot water flows through the spout. Let it flow for
approximately 10 seconds.
Stop the flow of water by simply returning the control button to PENDING
If there is no water flow, see the section "Safety and visual warnings".
Place a sufficiently large enough container under the dispensing unit without using the filter holder.
When the TEMPERATURE light (h6) stops flashing, briefly turn the Pre-programmed 2 cup espresso
button to the right and let the water flow (the machine's pump stops automatically when the
pre-programmed amount has been dispensed). If this does not work, see the paragraph "Safety and
visual warnings" p.25 and perform this action again.
IMPORTANT
It is possible that some steam may be released from the water tank. This is completely normal.
The water circuit has now been drained and your machine is ready for use.
2. COFFEE FUNCTION
Check that the power cord is connected.
Open the lid by pressing on both sides and open the lid to 90° without forcing
Fill the tank without exceeding the MAX marking at the overflow opening (Fig.7 and 8) .
Ensure that the filter holder is correctly positioned (i.e. fully inserted into its opening). Do not insert filter
paper or coffee.
Close the lid until you hear the click indicating that it is firmly locked (Fig.11) .
Position the coffee pot on the warming plate.
Check that the rotating control button is set to PENDING
Switch the machine on by turning the START/STOP button(h7) to the
The TEMPERATURE light (h6) flashes but for the FILTER COFFEE function you do not have to wait
for it to stop flashing.
Turn the FILTER COFFEE button
coffee is dispensed after a few seconds.
14
( ) (fig.4) .
I /
to the right; the COFFEE FILTER light (h1) comes on and the
( ) and that the TEMPERATURE
.
I / is set on ( )
(I) setting.
( ) (Fig.4) .
(Fig.5 and 6) .
(I) setting.