Grounding Instructions; Check Operation - Frigidaire FGC3X4XAWE Instrucciones De Instalación

GAS COOKTOP INSTALLATION INSTRUCTIONS

Grounding Instructions

For personal safety, this appliance must be
properly grounded.
The power cord of this appliance is equipped with a 3-
prong (grounding) plug which mates with a standard 3-
prong grounding wall receptacle (see Figure 8) to
minimize the possibility of electric shock hazard from the
appliance.
The wall receptacle and circuit should be checked by a
qualified electrician to make sure the receptacle is
properly grounded.
Figure 8
Where a standard 2-prong wall receptacle is installed, it
is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded 3-
prong wall receptacle.
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Disconnect electrical supply cord from wall
receptacle before servicing cooktop.
(For Models with 4 Sealed Burners, Porcelain Enamel Cooktops)

Check Operation

Refer to the Owner's Guide packaged with the cooktop
for operating instructions and for care and cleaning of
your cooktop.
Do not touch the burners. They may be
hot enough to cause burns.
1. Install Burner Caps
This cooktop is equipped with sealed burners as
shown (see Figure 9).
A. Unpack burner caps and trim rings.
B. Place trim rings over each burner.
C. Make sure the burner is properly aligned and
leveled. Find the locating tabs under each burner
cap, and place them in the recesses in the
burner base as illustrated.
NOTE: There are no burner adjustments necessary on
this cooktop.
Use caution when replacing the burner
cap so the electrode is not damaged.
2. Turn on Electrical Power and Open Main Shutoff
Gas Valve
3. Check the Igniters
Operation of electric igniters should be checked after
cooktop and supply line connectors have been
carefully checked for leaks and the cooktop has
been connected to electric power. To check for
proper lighting:
6
Recess
for Tabs
Figure 9