stayer HL 11B Manual De Instrucciones página 20

gb
Replaceable Parts Table / T1
Symptom
Motor refuses to start
Motor stops
Fuses blow
Excessive working pressure
Pressure pulsating
Pressure too low, but steady Note!
Several types of
normally deliver a lower pressure
Motor starts up but no working
pressure
The pressure washer starts irregularly
by itself
Water leaks from machine
Accessories and spare parts
Only use accessories and spare parts which have been approved by STAYER. Original accessories and spare parts
guarantee that the unit can be operated safely and without any breakdowns.
- Plug not connected
- Mains socket faulty
- Fuse faulty/blown
- Extension cable damaged
- Motor protector has activated
- Frozen
- Fuse faulty/blown
- Wrong mains voltage
- Motor protector has activated
Fuses faulty/blown
Nozzle partly blocked
- - Air in the inlet water supply hose/
pump
- Inadequate water supply
- Water strainer blocked
- Water supply hoses squeezed
- High pressure hose too long
- Nozzle worn
accessory will
- Start/stop valve worn
- No water supply
- Water strainer clogged up
- Nozzle clogged up
Pump/power gun leaky
Leaking pump
ENGLISH
20
Possible Cause
20
Remedy
- Connect plug
- Use another socket
- Replace fuse
- Try without extension cable
- Allow to cool for 5 minutes
- Wait for pump/water supply hose/
accessory to thaw
- Replace fuse
- Check that mains voltage corresponds
to specifications on the model tag
- Allow to cool for 5 minutes
Change to a mains supply higher than
the pressure washer amp consumption
Clean nozzle
- Allow pressure washer to run with
open spray handle and nozzle at
low pressure until regular working
pressure is obtained.
- Check that the water supply
corresponds to specifications.
The minimum specification for the
water supply hose is 1/2" or 13 mm
diameter.
- Clean water strainer
- Straighten out kinked water supply
hoses
- Dismount high pressure extension
hose. Retry (extension hose max. 7
m)
- Change the nozzle
- Activate trigger five times in quick
succession
- Connect water supply
- Clean the water strainer
- Clean nozzle
Contact your STAYER Service Centre
6 drops per minute are permissible.
In case of more serious leakage, you
should contact your STAYER Service
Centre.