Troubleshooting - Eco-Flo SUP55PC Manual Del Propietário

TROUBLE SHOOTING CHECKLIST
PROBLEMS
PUMP WILL NOT START
OR RUN
PUMP STARTS AND
STOPS TOO OFTEN
PUMP WILL NOT SHUT
OFF OR RUNS
CONTINUOUSLY
PUMP OPERATES BUT
DELIVERS LITTLE OR
NO WATER
ELECTRICAL PRECAUTIONS
Before servicing a pump, always shut off the main power breaker and
then unplug the pump. Make sure you are not standing in water and are
wearing insulated protective sole shoes, under flooded conditions. Contact your local electric
company or a qualified licensed electrician for disconnecting electrical service prior to pump
removal
4
POSSIBLE CAUSES
1. Tripped home electrical breaker
2. GFCI tripped
3. Low line voltage
4. Defective motor
5. Dirty switch
6. Impeller obstructed
7. Inlet screen or strainer clogged
8. Priming hole plugged
1. Back flow of water from piping
2. Dirty switch
3. Pump is sitting uneven on pool or
spa cover
1. Debris in switch
2. Discharge height exceeds capability
1. Impeller obstructed
2. Obstructed hose
3. Discharge height exceeds capability
4. Strainer clogged
(Caution: shut off power to pump)
CORRECTIVE ACTION
1.
2.
3.
4.
5.
6.
7. Clean inlet screen and debris strainer
8. Clean hole, inside volute housing, with a
1.
2.
3.
1. Rinse out switch with clean water (Fig 2)
2. Reduce discharge height
1.
2.
3.
4.
Reset breaker
Check for damaged wiring or moisture
Contact electrician
Replace pump
Rinse out switch with clean water
Remove strainer, base, and impeller
plate (Figure1) check for debris; clean
pin or paper clip (Figure 1)
Install or replace check valve
Rinse out switch with clean water
Reposition pump so pump sits level on
cover
Remove strainer, base, and impeller
plate, check for debris; clean
Check for kinks, reposition hose or
check for debris
Reduce discharge height
Unplug pump. Remove strainer and
rinse with clean water to remove debris