Cutting Advice; Dust Extraction Port - Evolution R165 CCS Li Instrucciones Originales

www.evolutionpowertools.com

CUTTING ADVICE

• Do not force the machine.
• Allow the speed of the saw blade do the
work. Cutting performance will not be
improved by applying excessive pressure to
the machine and blade life will be reduced.
• When using the parallel edge guide, ensure
that it is parallel with the blade. The blade
and/or motor could become damaged if
the machine is used with an incorrectly
adjusted parallel edge guide.
• Place front edge of sole plate squarely on
the workpiece. Before starting the motor
ensure that the blade is not in contact with
the workpiece.
• When starting a cut, taking care to
introduce the blade to the material slowly,
so as not to damage blade teeth.
Note: Two line of cut guides are provided at
the front of the sole plate of the machine (for
0 and 45 bevel angles only).
0 0
• Use both hands to move the saw forwards
through the work piece.
• Apply smooth, constant pressure to move
the saw forwards through the workpiece.
Note: The machine has an automatic lower
blade guard which has a specially shaped
leading front edge. This feature ensures
that the blade guard retracts smoothly and
effortlessly as the machines blade enters the
workpiece. As the blade exits the workpiece
the lower blade guard will automatically
return to its normal position covering the
blade completely.
Note: On some occasions e.g. making a
plunge cut into a floor or wall etc it may be
advantageous to retract the lower blade
guard manually.
A thumb operated lever is provided on
the lower blade guard. With care, a skilled
operator can retract the blade guard
manually, either partially or fully, allowing
plunge cuts to be made.
WARNING: If retracting the blade guard
manually great care must be taken to ensure
that the operators hand or fingers do not
touch any part of the machines blade.
When a cut has been completed:
• Release the ON/OFF Trigger switch.
• Allow the blade to come to a
complete stop.
• Remove the machine from the workpiece
allowing the lower blade guard to return to
its normal position covering the blade.
WARNING: If the motor should stop or stall
whilst a cut is being attempted release the
trigger switch immediately. Remove the
battery from the machine and remove the
machine from the workpiece.
Investigate the cause of the problem and
rectify if possible.
Only attempt to restart the motor when you
are absolutely sure that it is safe to do so.

DUST EXTRACTION PORT

WARNING: Do not use the dust bag and dust
port adaptor when cutting metallic materials
including wood with nails.
17
EN