Tabla de contenido
SAFETY, OPERATORS, MAINTENANCE & PARTS MANUAL
7
MAINTENANCE & LUBRICATION
Read the Safety Instructions
Lubricate the following with Shell Darina R2 grease.
Cutting cylinder
bearings (A)
weekly or every 25 hours.
Unit pivot (B)
weekly or every 25 hours.
Roll bearings (C)
weekly or every 25 hours.
en-14
JACOBSEN FAIRWAY & T-PLEX CUTTING UNITS
SAFETY, OPERATORS, MAINTENANCE & PARTS MANUAL
7
MAINTENANCE & LUBRICATION
Read the Safety Instructions
Check all nuts and bolts every 75 hours
Lubrication of Direct Drive Hydraulic Motor
(Every 400 hours)
Lower all cutting units onto level ground. Before
leaving the driving position, stop the engine and
make sure all moving parts are stationary. Apply
brakes and disengage all drives. remove the
starter key. The direct drive hydraulic motor can
be removed from the cutting unit by removing
the two screws and washers holding the motor
to the bearing housing. Carefully withdraw the
motor from the bearing housing, it is important
not to contaminate the motor shaft or internal
splines of the cutting cylinder. If for any reason
they are contaminated, they should be cleaned
by degreasing. Liberally lubricate the motor and
cylinder splines with Shell GADUS S2 V220AD 2
(4273711) before reassembling.
JACOBSEN FAIRWAY & T-PLEX CUTTING UNITS
en -15
Tabla de contenido
