Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Tilting the work table
1. The worktable can be tilted left or right by loosening the pivot bolt.
2. When returning the table to the level position, line up the register mark with the tilt
scale.
Changing spindle speeds
1. Switch machine off and unplug it.
2. Open the pulley cover. (Fig.6)
3. Undo the Belt Tension Locking Knob (Fig.8) to relieve any tension on the belt, and
referring to the chart, install the belt in the position corresponding to the spindle
speed required.
4. Lever the motor, on its bracket, away from the head, so that tension is applied to the
belt. Tension is correct, when the belt deflects by approx. ½" at its centre, when
using reasonable thumb pressure. Lock the motor in this position using the Locking
Knob.
Diag.1
Note:
Tighten the belt only so far that the slippage is eliminated.
A too tight belt will deform during a longer period of rest, which reduces the power of
the motor.
Spindle stop
Your drill press is equipped with a depth stop for drilling multiple holes to a specific
depth.
1. Put drill bit in chuck.
2. Lower the chuck with the power OFF, until the drill contacts the surface of the
work piece, and hold in that position.
3. Turn the stopper nut ring (Fig.5) until the pointer is aligned with the desired depth of
All manuals and user guides at all-guides.com
12
Tabla de contenido
