LUND SR2 Instrucciones De Instalación página 3

7. Continue along the cab to the rear mounting location and locate the last (2) mounting holes in the pinch
weld at the back of the cab, (Figure 1). Repeat Steps 2—5 for rear Bracket installation, (Figure 10).
8. Select (1) Running Board and (3) 8mm Double Bolt Plates, (Figure 11). Place the Running Board on
top of the (3) Brackets. Insert the Bolt Plates into the channel in the bottom of the Running Board
closest to the Brackets, (Figure 12). Lift the Running Board up and guide the studs down through the
Brackets. IMPORTANT: Do not slide the Running Board on the Brackets, (front to back or rotate), or
the finish on the Running Board may be damaged.
9. Attach the Running Board to the Brackets with (6) 8mm x 24mm Flat Washers and (2) 8mm Nylon Lock
Nuts, (Figures 13—16). Do not tighten hardware at this time.
10. Level and adjust the Running Board and tighten all hardware.
11. Repeat Steps 2—10 for Running Board installation on the passenger side.
12. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap
may be used to clean the Running Board.
Locate holes through pinch
weld (arrows) to determine
mounting locations
(Fig 1) Driver/left inner body panel illustrated
(Fig 3) Slide 8mm Clip Nuts over holes
Driver/Left Side Installation Pictured
Front
Page 2 of 5
09-14 FORD F-150 SUPER CREW CAB
Front
(Fig 2) Driver side front mounting location
SR2 RUNNING BOARD
11/30/17 (RA)