Vivotek SD8363E Guía De Instalación Rápida página 12

4
Network Deployment
General Connection
1. Connect the Network Camera's Ethernet cable (CAT5e) to a PoE Plus switch. A 30W
PoE output port alone can not drive the onboard heater, and hence if using the PoE
switch alone, the application does not apply in low-temperature condition. The 30W PoE
plus can only drive the camera when it is working at a temperature higher than -5ºC.
2. Connect the power wires to an AC 24V power adaptor (user-supplied). The AC 24V
adapter can drive the camera and the onboard heater.
You can connect both power sources for redundancy in power supply.
Power over Ethernet (High Power PoE)
When using a non-PoE switch
Use a High Power PoE power injector (separately purchased) capable of 60W output to
connect between the Network Camera and a non-PoE switch. Sufficient power is required
for low temperature conditions when the onboard heater is activated.
All manuals and user guides at all-guides.com
EN-11
IEEE 802.3at PoE Switch (30W output)
and / or
AC 24V 3.5A Adapter
(User-supplied)
High Power PoE Power
Injector
Non-PoE Switch