GM 20951290 Manual De Instrucciones página 2

6. There are locking features on front clamps only. With the
handle engaged (clamped position), push the locking tab on
the handle to engage lock. See Figure 4.
FIGURE 4
7. Repeat clamp attachment steps 3 thru 6 for the opposite
side.
TO CLOSE THE TONNEAU COVER
1. Unbuckle both retention straps located on the top of the
cover behind the cab and snap into stored position. See
Figure 5.
FIGURE 5
Folding Tonneau Cover
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION AUTH
2. Unfold tonneau cover to the closed position.
3. Lower the rear set of handle/clamp assemblies from stored
position.
4. Tilt the handle/clamp assembly so that the locator is in the
slot, pull down on the assembly, and slide the clamp under
the edge of the inner lip of the bed rail. See Figure 2.
5. Secure the clamp to bed rail by pulling the handle toward
the rear of the truck bed ensuring the locator is in the slot.
See Figure 3. Verify the clamp is securely and properly
engaged by lightly shaking handle assembly. The handle
should not move.
5a. If clamp is too loose:
1. Push handle forward to release from clamped
position.
2. Disengage clamp from inner lip of bed rail and slide
assembly inboard.
3. Adjust clamp height on bolt by rotating the entire
clamp/handle assembly COUNTER-CLOCKWISE
(as viewed from the top).
4. Reattach clamps as indicated in steps 4 and 5.
5b. If the clamp is too tight (cannot rotate handle or exces-
sive force is required to do so):
1. Return handle to the fully disengaged position.
2. Disengage clamp from inner lip of bed rail and slide
assembly inboard.
3. Adjust the clamp height by rotating the entire clamp/
handle assembly CLOCKWISE.
4. Reattach clamps as indicated in steps 4 and 5.
6. Repeat clamp attachment steps 3 thru 6 for the
opposite side.
7. Close the endgate.
TO OPEN THE TONNEAU COVER
1. Rotate both rear handles inboard to release compression.
2. Pull clamps down and rotate assemblies to disengage from
the lip of the truck box.
3. Once handles are released, rotate the panel to the open
position
4. Align the clamp assembly bolt (shaft of the handle) with the
retention feature and rotate handle assembly flat onto the
panel and press firmly to secure. See Figure 9.
IMPORTANT : IF STOWING COVER COM-
PLETELY, FAILURE TO DO THIS STEP MAY RE-
SULT IN DAMAGE TO THE COVER SURFACE,
FROM HANDLE TO COVER OUTER SURFACE
CONTACT !!!
REV )(11 PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Folding Tonneau Cover
PART NO.
20951290
6200 Grand Pointe Dr., Grand Blanc, MI 48439
20951290
SHEET
2
SHEET
2 9
OF
9
OF