Advanced Operation - KlipXtreme NITRO KBS-025 Manual

IV. Advanced operation
Note: Before installing this product, please make sure your device has the built-in
feature available.
Bluetooth ®
Pairing the speaker with your mobile device
1. Press and hold the ON/OFF button on the speaker to turn it ON.
2. Set your Bluetooth phone to "discover" the wireless speaker.
®
3. Place both devices not more than one meter away from each other.
4. The blue LED light starts blinking, accompanied by a voice prompt indicating
that the device has entered into the pairing mode and is ready to be detectable
for the first time.
5. On your mobile phone, tap the newly discovered audio device (KBS-025)
displayed in the Bluetooth list.
®
6. If you have a lower Bluetooth version, you may be prompted to enter the
®
passkey 0000 (4 zeros).
7. If pairing is successful, a voice prompt will be heard and the LED light will turn
solid blue. If after 60 seconds the pairing process fails, please repeat steps 1
through 6 described above.
8. We recommend turning off the device when not in use to conserve battery
power. The speaker will shut off after approximately ten minutes of inactivity, if it
is not connected to the Bluetooth
®
device connected and stored in the memory once it has been turn off and on
again.
All manuals and user guides at all-guides.com
device. It will automatically connect to the last
V. Enabling the TWS feature on the speaker
Note: The TWS feature is automatically enabled, and two identical speakers are
necessary in order to make it work.
1. To turn on the speakers, press and hold the ON/OFF
seconds on each unit, simultaneously. The blue LED will start blinking quickly in
one of the speakers, automatically making it the secondary unit. The LED light will
eventually turn solid blue when paired to the primary device.
2. The remaining unit with the blinking LED light will automatically become the
primary device. The LED will remain blinking while it is in pairing mode with your
mobile device.
3. Press and hold the ON/OFF
unit off. However, if the two are linked, then both will be powered off
simultaneously upon pressing this button on the master unit.
4. Every time the speakers are switched on and off, a voice prompt will be heard
to indicate the state that each unit is currently in.
VI. Using the speaker to answer and end a call
• When there is an incoming call, the speaker will generate a tone to alert you of this
event.
• Briefly press the Play/Pause button to pick up. You may also press the answer
button on your cellular phone to take the call using the speaker.
• Speak with a clear voice right into the built-in microphone of the speaker.
button for about 3
button again for about 3 seconds to turn each