Getting Started - Bellman & Symfon BE1441 Manual Del Usuario

26
Bellman Visit Flash Receiver, BE1441/1442/1443
Thank you for choosing products from Bellman & Symfon.
The Bellman Visit System consists of a number of radio transmitters and receivers. The
transmitters detect different events in the surrounding area and transmit a radio signal to
the receivers. The receivers pick up this signal and provide indications using light, sound
and/or vibration.
The transmitter determines what type of light, sound or vibration should be displayed so
that the reason for the indication is evident.
Read through the entire user manual first and then start to install the system.
Refer to the illustration of the Bellman Visit System on the inside of the cover.

Getting started

Unpacking, installing and testing the unit
1 Connect the power supply unit to the socket
Bellman Visit Flash Receiver will then start flashing and if a BE1270 Bellman Bed-shaker
(accessory) is connected, it will vibrate.
2 A Bellman Visit transmitter is required to test the radio reception. Press the Test Button
on the Bellman Visit Transmitter. The Bellman Visit Flash Receiver will then start flashing,
emitting a light signal, and if a BE1270 Bellman Bed-shaker (accessory) is connected, it
will vibrate.
3 It can be connected to an analogue telephone socket via the telephone input
the BE9105 Telephone Flex (accessory) and an adapter plug (accessory). When someone
rings the phone number, the Bellman Visit Flash Receiver will start flashing, the yellow
LED will light up and, if a BE 1270 Bellman Bed-shaker (accessory) is connected, it will
vibrate.
4 Place the Bellman Visit Flash Receiver upright on a level surface or mount it on the wall
using the BE9075 Bellman Wallmount Bracket (accessory). The receiver should be placed
where it can best be seen.
GB
. Press the Test Button (9). The
with
Function
General
The BE1441/1442/1443 Bellman Visit Flash Receiver is a receiver within the Bellman Visit
system for indoor use, which attracts the attention of the user with a flashing light, light
signal, and also by vibration if a BE1270 Bellman Bed-shaker (accessory) is connected.
It is activated via radio signals from one of the Bellman Visit System transmitters or via
direct connection to an analogue telephone socket.
The flash head can be rotated to point in the direction required. The flash head can, for
example, be pointed towards a wall to prevent dazzle. A short press on the Test Button (9)
activates BE1441/1442/1443 so that it repeats its last indication.
Radio key
On delivery all Bellman Visit units are tuned to the same Radio Key. If you have a neighbour
with a similar system, you can change to different Radio Keys so that you do not affect each
other's systems.
The Radio Key on this receiver can be changed by holding down the Test Button (9) for
about five seconds until the LEDs and
test button so that the receiver's LEDs
been changed. All units in a Bellman Visit System must have the same Radio Key in order to
operate as a group. Refer to the user manual for the relevant unit.
Indicators and Signals
It is generally the transmitters in the Bellman Visit System that determine how the receiv-
ers will indicate an alarm. See the description in the relevant transmitter user manual for
further information.
The Bellman Visit Flash Receiver has a function which allows you to easily check which
alarm was the last one detected. Give a short press on the Test Button (9) and the last alarm
will be repeated.
blink alternately. Then press the transmitter's
blink to confirm that the Radio Key has
27
CZ
DE
DK
ES
FI
FR
GB
GR
HU
IT
NL
NO
PL
PT
SE
SRB
APP