Commissioning And Operation; Initial Start-Up - Kärcher K 4.92 M Manual De Instrucciones

Commissioning and operation

Definition of abbreviations used:
HP = High pressure
DT = Detergent
Description of the Appliance
When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
Illustrations on Page 2
1 ON/OFF switch for appliance
2 Power cable with plug
3 HP outlet
4 HP hose
5 Handgun with safety catch
6 Connection for water supply with filter
7 Coupling element for water connection
8 DT tank
9 DT suction hose with filter
10 Accessory mount, handspray gun
11 Accessory mount, HP hose
12 Accessory mount, Spray lance
13 Transport handle
14 Spray lance with Variopower nozzle
15 Spray lance with dirt blaster
16 Washing brush

Initial start-up

When the appliance is delivered, the HP
hose and handgun are not attached, this
prevents buckling. Please mount these be-
fore using the appliance for the first time.
" Push out the safety clip in the handgun
using e.g. a small screwdriver.
" Join HP hose and handgun together.
" Push clip in until it engages and check
that it is securely fastened by pulling on
the HP hose.
" Remove cable tie and unroll HP hose
All manuals and user guides at all-guides.com
Water supply from mains
For connection values, see type plate/tech-
nical data.
Observe regulations of water supplier.
" Use a fibre-reinforced hose (not includ-
" Screw the coupling unit (supplied) to the
" Push the water supply hose onto the
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the HP pump.
If the water supply is not clean, the Kärcher
water filter must be used (special accessory
- order No. 4.730-059).
Drawing in water from open reservoirs
When fitted with the appropriate accesso-
ries, this high-pressure cleaner can draw in
surface water, e.g. from water butts or ponds
(max. suction height 0.5 m).
" Use the Kärcher water filter to protect the
" As the standard coupling system is not
" Remove air from appliance before oper-
Water supply
ed) with a standard coupling: - Minimum
diameter, 1/2 inches (13 mm). - Mini-
mum length, 7.5 m.
water connection on the appliance.
coupling unit, then connect it to the tap.
Caution
HP pump and accessories (special ac-
cessories, order no. 4.730-059). This fil-
ter removes dirt from incoming water.
suitable for use in suction mode, the
Kärcher suction hose with integrated fil-
ter should be used instead (special ac-
cessory, order no. 4.440-238) and
suspended inside the water butt.
ation: Switch on the appliance when the
HP hose is not connected and run it until
the water which discharges from the HP
outlet is free of bubbles. Switch off ap-
pliance and connect HP hose.
Note: The appliance deaerates faster if
you first fill the suction hose with water.
11
English