Thomasville Carmel Serie Manual De Instalación página 8

6. Align the holes at the bottom of
the downrod with holes in the collar on
top of the motor housing (Figure 7).
Carefully insert the hanger pin through
the holes in the collar and downrod. Be
careful not to jam the pin against the
wiring inside the downrod. Insert the
locking pin through the hole near the
end of the hanger pin until it snaps into
its locked position as noted in the
circle inset of Figure 7.
7. Re-tighten the set screws on the
collar on the top of the motor housing.
WARNING
FAILURE TO PROPERLY
LOCKING PIN AS NOTED IN STEP 6
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
CLOSE-TO-CEILING
MOUNTING
1. Remove the canopy ring from the
canopy by turning the ring to the right
until it unlocks (Figure 5).
2. Remove the mounting plate from
the canopy by loosening the four
screws on the top of the canopy.
Remove the two non-slotted screws
and loosen the slotted screws. This
will enable you to remove the
mounting plate (Figure 6).
3. Remove the decorative canopy
bottom cover from the canopy by
depressing the three studs (Figure 8).
Figure 8
4. Remove three of the six screws and
lockwashers (every other one) securing
INSTALL
the motor collar to the top of the fan
motor housing (Figure 9).
5. Route the wires exiting the top of the
fan motor through the plastic gasket,
canopy ring, canopy and the metal
gasket, place the plastic gasket over the
remaining three screws, place the
canopy ring, canopy and the metal
gasket over the motor collar at the top
of the fan motor (Figure 10).
6. Align the three mounting screw holes
on the metal gasket with the holes on
the motor collar at the top of the fan
motor and fasten, using the three screws
and lockwashers provided with metal
gasket.
7. Tighten the three mounting screws
securely.
Figure 10
5.