Operating The Fan; Operating Your Remote Control 12 - Thomasville Carmel Serie Manual De Instalación

Setting the Code
This unit has 16 different code combinations.
To set the code, perform the following steps.
A. Setting the code on the transmitter:
a. Remove the battery cover
compartment in the back side of the transmitter.
b. Slide code switches to your choice of up or down
position (factory setting is all up).
B. Setting the code on the receiver:
a. Slide code switches to the same position as set on
your transmitter.
b. Re-place the battery cover on the battery compartment
of the transmitter.
CAUTION: Ceiling angle shall not exceed 45 degrees.
Remote Control Model: UC7067RYL
Installing Receiver
WARNING: To reduce the risk of fire or electric shock,
remember to disconnect power. Do not use solid state fans,
electrical wire must meet all local and national electrical code
requirement. Electrical source and fans must be 115/120 volt,
60Hz. Maximum fan motor amps: 1.0. Maximum light watts:
300-incandescent only.
A. Wire connection:
Fan Green Wire
Black Receiver Wire (AC IN L)
White Receiver Wire(AC IN N)
White receiver Wire(TO MOTOR N)
Black Receiver Wire(TO MOTOR L)

Operating Your Remote Control 12.

Blue Receiver Wire(FOR LIGHT)
NOTE: If other fan or supply wires are different color, have
this unit installed by a licensed electrician.
B. Lay the black antenna wire on top of the receiver and slide
the receiver into the mounting plate.
from the battery
Operating Transmitter
Install a 12 volt battery (included).
This remote is equipped with 16 code combinations. To
prevent possible interference from or to other remote units
such as garage door openers, car alarm or security system,
simply change the combination code but be sure that the code
on both transmitter and receiver are matched.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions:(1) This device may
not cause harmful interference and (2) This device must accept
any interference received, including interference that may
cause undesired operation.

Operating the fan:

●●● Key---High Speed
●● Key--Medium Speed
● Key---Low Speed
Bare Supply Wire
Key---Light On/Off and Dimmer
Black Supply Wire
Key (inside the battery compartment in the back side of
White Supply Wire
the transmitter) -Fan Reversing Function
White Fan Wire
Key---Fan Off
■
Black Fan Wire
Blue Light Wire