6.A
6.B
Ensure your descaling product
The Coffee & Tea Buttons
is suitable for coffee machines;
will quickly flash, immediately
follow descaling product
after switching on, to indicate
instructions carefully. If
descaling is required. Ensure
you are using a water softener,
your descaling product is suitable
ensure water softener is
for coffee machines and follow
removed before adding
descaling product instructions
descaler. Fill water tank with
carefully.
descale solution.
6.D
6.E
Insert Water Tank. Turn on
Ensure the Lever is pushed
and wait for the Coffee & Tea
down fully and no capsule is
Buttons to stop flashing. Press
present, then press the Coffee
both Coffee & Tea Buttons
Button to start descaling. Your
firmly at the same time and
machine will dispense. This will
hold for 5 seconds. Both
continue until the Water Tank is
Buttons will now quickly flash.
empty. Wait 10 minutes for the
Descaling Solution to take effect.
6.G
To exit the Descale Mode, press
both Coffee & Tea Buttons at
the same time and hold for
5 seconds. Both lights will
go back to solid illumination.
NOTE: if the machine is turned
off in Descale Mode, it will stay
in this mode when switched
back on. If you are using water
softener, ensure that it is placed
back into the Water Tank once
the Water Tank is clean.
6.C
Ensure the correct ratio of water
is used to create the Descaling
Solution. Turn the machine off,
remove the Water Tank and
fill with the Descaling Solution.
Remove Drip Tray and place
large container under the nozzle.
6.F
Rinse the Water Tank and fill
with fresh water. Repeat step
6.E and flush at least two full
tanks of water through the
machine to remove any traces
of the Descaling Solution.
14
CLEANING
AFTER EACH USE
BEFORE CLEANING, MAKE SURE THERE IS NO CAPSULE IN THE MACHINE,
FOLLOW STEP 1 AND THEN SWITCH OFF, UNPLUG AND ALLOW TO COOL.
7.A
7.B
Ensure the Lever is pushed
Remove the Drip Tray and
down and no capsule is present.
Capsule Basket assembly, then
Press the Coffee Button. Water
lift the Capsule Basket out of the
will flush through the machine
Drip Tray. WARNING: Drip
and into the Drip Tray. Then
Tray will be hot after use.
switch off, unplug and allow
Handle with care - risk of
to cool.
scalding.
7.D
7.E
Use a small brush to remove
Wipe down the body and
any build up of debris on the
Nozzle of the capsule machine
Filter Plate. A soft toothbrush
with a damp, non abrasive cloth.
or something similar works
well. A torch may be useful to
check the plate is completely
clean. Once cleaned, follow
the descaling process to clean
inaccessible parts within the
machine. Caution: Do not
use sharp implements, risk
of machine damage.
WWW.DUALIT.COM/REGISTER
DON'T FORGET
TO REGISTER
YOUR PRODUCT
OR BY POST
7.C
Empty and Rinse the Drip Tray
and Water Tank into the sink
after each session. Refill the
Water Tank with fresh water,
just before you make your next
beverage.
15