Tool Assembly - Milwaukee 0233-20 Manual Del Operador

WARNING!
To reduce the risk of injury, al-
ways unplug tool before attaching
or removing accessories. Use
only specifically recommended
accessories. Others
hazardous.
Removing and Replacing Quik-Lok
Cords (Fig. 1)
MILWAUKEE 's exclusive Quik-Lok
provide instant field replacement or
substitution.
Fig. 1
1. To remove the Quik-Lok
cord nut 1/4 turn to the left and pull it
out.
2. To replace the Quik-Lok
connector keyways and push the con-
nector in as far as it will go. Turn the
cord nut 1/4 turn to the right to lock.
Installing Side Handle (Fig. 2)
MILWAUKEE Magnum Drills are supplied
with a side handle that can be installed on
either side of the tool for right or left handed
use. To install the side handle, thread it into
the socket on the desired side of the tool
and tighten it securely. Always use the side
handle for best control.
Fig. 2
All manuals and user guides at all-guides.com

TOOL ASSEMBLY

may be
Installing Bits into Keyed Chucks (Fig. 3)
Cat. No. 0234-1, 0244-1
®
®
Cords
1.
®
Cord, turn the
®
Cord, align the
2.
3.
4.
7
WARNING!
To prevent personal injury, al-
ways remove the chuck key from
the chuck after each use.
Fig. 3
Tighten
Open the chuck jaws wide enough to
insert the bit. Be sure the bit shank and
chuck jaws are clean. Dirt particles may
prevent the bit from lining up
properly.
When using drill bits, insert the bit into
the chuck. Center the bit in the chuck
jaws and lift it about 1/16" off of the
bottom. Tighten the chuck jaws by hand
to align the bit.
When using screwdriver bits, insert the
bit far enough for the chuck jaws to
grip the bit shank. Tighten the chuck
jaws by hand to align the bit.
Place the chuck key in each of the three
holes in the chuck, turning it clockwise
as shown. Tighten securely.
To remove the bit, insert the chuck key
into one of the holes in the chuck and
turn it counterclockwise.
Loosen