Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer helpline
at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
•
Main Unit
•
Handle
•
Accessory Tray with Hose Wrap
•
High Pressure Hose
•
Spray Gun
•
Nozzle Extension with Quick Connect Fitting
•
Quick Connect Selector Nozzle
•
Oil Bottle
•
Quick Switch™ PerfectMix™ Assembly
•
PerfectMix™ Detergent Hose
•
Parts Bag (which includes the following):
•
Operator's Manual
•
Owner's Registration Card
•
Handle Fastening Hardware Kit (which includes):
•
Handle Bolts (2)
•
Plastic Knobs (2)
•
Tree Clips (6)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Connect PerfectMix™ detergent hose to pump and Quick
Switch™ PerfectMix™ assembly.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Attach quick connect selector nozzle to nozzle extension.
ASSEMBLY
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports connected to
main unit. Make sure holes in handle align with holes on
handle supports.
A
2. Insert handle carriage bolts (B) through holes from
inside of unit and attach a plastic knob (C) from outside
of unit. Tighten by hand.
NOTICE By loosening both knobs to the middle section of
the attachment bolt, the upper handle can fold forward to
store flat atop the cold engine. DO NOT fold the handle down
while the engine is hot.
3. Insert rubber straps (D) through slots (E) in back of
accessory tray and pull tight from front.
D
E
4. Place accessory tray (F) over holes (G) on handle
(viewing from front of unit). Push the tree clips (H) into
the holes until they sit flat against the accessory tray.
H
G
7
C
B
F
Capítulos
Tabla de contenido
