Electrical Connections - Craftmade VE56 Instrucciones De Instalación

10
Step 10
Attach canopy (5) by tightening
screw (S2) against side of downrod.
Tighten screw firmly.
11
1 Remove existing wall plate and switch, if applicable.
2. Remove 3/4" (1.9cm) of insulation from each circuit conductor. Make
sure the ends of wires are straight.
3. Connect wires as follows: connect black wires to black wires and green
wire to green. Screw connectors on clockwise making sure no bare
conductors show below the wire connectors.
4. Push all wires carefully into outlet box. Mount fan speed control into
box with mounting screws supplied. Attach wall plate and knob.
5. Turn knob clockwise to turn fan ON. To lower fan speed continue to
turn knob clockwise . To increse fan speed turn knob counter clockwise.
All manuals and user guides at all-guides.com
Canopy (5)
Screw (S2)
Step 11
Black Wires
Green
(ground wires)
Black Wires
12
Ceiling Connect black and blue (if provided) fan wires to black outlet wire. Connect
white fan wire to white outlet wire and green grounding lead wire from the
grounding conductor to the supply circuit (see figure A). Use wire connectors
provided with your fan. No loose strands or loose connections should be
present. After wires have been connected, they must be spread apart so the
green and white are on one side of the outlet box and the black and blue
are on the other side. Turn splices upward and carefully push all wiring into
outlet box. For optional wall control see figure B or Figure C for alternate
wiring. When wall switches are employed, switches should be UL listed for
use with ceiling fan.
NOTE: Make sure fan on/off switch is always at "high speed" location if your fan is
controlled by additional wall switch.
Black

Electrical Connections

Ground
White
Black
Green
White