Tabla de contenido
other equipment should be observed to verify that they are operating normally.
• Portable RF communications device (including peripherals such as antenna cables and external
antennas) should be used no closer than 12 inches (30 cm) to any part of the device, including
cables specified by FOREO. Otherwise, degradation of the performance of the monitor
could result.
• Use of accessories and cables other than those specified or provided by FOREO could result in
increased electromagnetic emission or decreased electromagnetic immunity of the equipment
and result in improper operation.
• Refer to further guidance below regarding the EMC environment in which the device should
be used.
Table 1: EMISSION Limits and Compliance:
Phenomenon
Conducted and radiated RF EMISSIONS
NOTE: EMISSION tests for Harmonic distortion, Voltage fluctuations and flicker are not
applicable.
Table 2: IMMUNITY TEST LEVELS:
Phenomenon
Electrostatic discharge
Radiated RF
electromagnetic fields
Proximity fields from RF wireless
communications equipment
Rated power frequency
magnetic fields
NOTE: IMMUNITY tests for Electrical fast transients / bursts, Surges Line-to-line, Surges
Line-to-ground, Conducted disturbances induced by RF fields, Voltage dips and Voltage
interruptions are not applicable.
6
Emission Limits
CISPR 11
Basic EMC standard
IEC 61000-4-2
IEC 61000-4-3
IEC 61000-4-3
IEC 61000-4-8
Compliance
Group1, Class B
Immunity Test Levels
±8 kV contact
±2 kV,±4 kV,±8 kV,±15 kV air
10 V/m
80 MHz to 2.7 GHz
80 % AM at 1 kHz
See Table 3
30 A/m
50Hz
Tabla de contenido
