Troubleshooting - Scheppach BGS700 Traducción Del Manual De Instrucciones Original

13. Troubleshooting

Problem
Motor doesn't start
Machine gets slower during
work.
Sanding belt comes off the
drive pulleys.
The wood gets burnt during
sanding.
28 | GB
Possible Cause
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
Too much pressure put on the workpiece.
Belt does not run straight.
a) Sanding disc or belt covered with
grease.
b) Excessive pressure on workpiece.
www.scheppach.com
Action
a-d) Replace all damaged parts be-
fore you use your machine again.
e) Contact your local service centre.
Every attempt to carry out a repair,
can be dangerous if it is not done by
skilled personnel.
Reduce the pressure on the work-
piece.
Reset the track.
a)Replace disc or belt.
b) Reduce pressure on workpiece.