Control Panel Assembly - SNOWJOE SUNJOE 24V-MDTCR1-CT Manual Del Operador

Detector de metales inalámbrico – solo herramienta

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

WARNING!

This charger does not automatically

turn off when the battery is fully charged. Please take care

not to leave the battery plugged into the charger. Switch

off or unplug the charger at the mains when charging is

complete.

5. Timely recharging of the battery will help prolong the

battery's life. You must recharge the battery pack when

you notice a drop in the equipment's power.

IMPORTANT! Never allow the battery pack to become fully

discharged as this will cause irreversible damage to the

battery.

6. When charging is complete, remove the battery from the

charger by pulling the push lock button and sliding the

battery backward to unlock it from the charger.

Assembly

The product must be fully assembled before operation. Do not

use the device when only partially assembled or assembled

with damaged parts. Follow these instructions to assemble the

metal detector.

Pole Assembly

1. Insert the lower pole into either end of the middle pole

until the locking button clicks into one of the holes.

(Fig. 4).

Fig. 4

Lower pole

2. Insert the upper pole into the other end of the middle pole

until the locking button clicks in one of the holes.

3. Adjust the length by pressing the locking buttons and

moving them into different holes along the shaft of the

middle pole. Tighten both locking collars once you have

set the desired pole length (Fig. 5).

Fig. 5

Locking

collars

Middle pole

Locking button

Locking collar

Upper pole

Locking

buttons

Search Coil Assembly

1. Fit the end of the lower pole between the 2 tabs of the

search coil and align the holes (Fig. 6).

Fig. 6

Align the holes

2. Secure them together with the search coil bolt and knob.

Then tilt the search coil to your desired angle and tighten

the search coil knob and bolt to secure it in place (Fig. 7).

Fig. 7

Search coil bolt