Tabla de contenido
Idiomas disponibles
Idiomas disponibles
11. lnstallation of Wire Controller
Safety Precautions
! Read the safety precautions carefully before installation.
! The following is the important content to be paid for the
safety, be sure to follow it.
The m eaning of each part:
lndicate it may cause the death or serious injury
• for the improper operation .
lndicate it may cause the death or serious injury
for the improper operation.
•Please do not install the wire controller in damp or direct sunlight
places.
•Please do not hit, throw and frequent disassembling the wire
controller.
•Please do not operating the wire controller with Wet hand ; Don't
make any fluid into the wire controller .
•Please do not do dismantling the wire controller without
authorization. Please consult after-sales maintenance personnel
lf you have a problem .
• To prevent water and dust into the wire controller, Affect the wire
controller normal use. Please dismantle the wire controller When
the indoor decoration and maintenancee .
lnstallation and disassembly of the wire controller
1, The installation position and requirements of the wire controller
1) Please do not install the wire controller in damp or direct sunlight
places.
2) Please do not install the wire controller in the places. where is near
the high temperatura or easy to splash water.
3) To avo id the interference of the neighbors' re mote controller which
has the same model , then cause abnormal work. Please do not install the
wire controller where the face up to the window.
4) Befo re installation , please cut off the power which is Buried in the
wall mounting hales. The whole installation process does not allow
operation with power.
5) In arder to avoid the unit by reason of electromagnetic interference
caused by abnormal work. When wiring , please pay attention to the
following matters.
A) Ensure that communication line access right, otherwise will lead to
communication failures.
B) lf the air conditioning unit is installed on the places , which is
influence by electromagnetic interference . the wire controller signal lines
mus! use shielded twisted-pair cable .
6) The standard accessories which is installation need to prepare
installed inside a wall socket bottom box, controller base plate, screw the
M4 x 25, control panel.
2, The installation of the wire controller
First of all, the wire controller signal line connection mode is as follows:
1) Open interior electrical lifted the lid, and the signal wires through the
Connect the wire controller in the way as shown in the figure below
Please use the 3-core shielded cable in
the attachment. lf the total wiring length
in the attachment is not long enough, it
can be lengthened. However, the overall
length shall not exceed 20m.
Wire
controller
Brief description of the installation process is as follows:
1) The signal lines of short through rectangle hale of the wire controller
bottom pi ate, and then pull out five core twisted pair from the wall
installation hale. Finally connect the line and the other end.
2) Use screws M4 x 25 to fix the controller base plate on the mounting
hales of the wall.
3) Pul the wire controller panel and floor buttons together, and this
installation is complete. When installation, please reserve a certain length
of the line al the bottom of box, to facilitate maintenance later removed.
3, Disassembly of the wire controller
! After the completion of the installation, confirm there is n o
abnormity for the comm issioning, and deliver the instruction
to customers for storage.
2
Electric control
board far indoor
unit
V.1
Tabla de contenido
