Uline KIHLBERG H-3070 Manual Del Usuario página 5

Staples are deformed when inserted.
Noise level is too high.
The carton is damaged by the
stapling head.
The carton is not pressed together
properly.
A staple is stuck in the staple head.
PAGE 5 OF 15
TROUBLESHOOTING CONTINUED
• Check that the stapling head bearing has no play.
• Check that the anvil is properly centered.
• Check that the driver is not damaged.
• Check that the staple channel is clean.
• Check that the air pressure is at 70 psi.
• Check that the stroke speed is not unnecessarily high.
• Check that the air pressure is at 70 psi.
• Check that the stroke speed is not unnecessarily high.
• Check that the length of the piston rod is adjusted properly.
• Remove the staple:
1. Pull the pusher back to take the pressure off the
staple strip.
2. Loosen the screws that hold the front plate.
3. Pull the staple downward to remove.
4. Retighten the screws.
1-800-295-5510
uline.com
0521 IH-3070