Uline H-7009 Manual Del Usuario página 2

NOTE: Two person assembly required.
NOTE: Do not tighten bolts until instructed.
NOTE: Bolt heads should face towards the
outside of the cabinet for added security.
1. Place one side panel on the ground with the flat
side down.
2. Attach back panel to side panel using three
M6 x 16 mm bolts and nuts for 4 cylinder cabinet
or four M6 x 16 mm bolts and nuts for 8 cylinder
cabinet. (See Figure 1)
NOTE: Back panel should be positioned behind
side panel.
Figure 1
3. Rotate cabinet on its back and place three
M6 x 16 mm bolts for 4 cylinder cabinet or four
M6 x 16 mm bolts for 8 cylinder cabinet through the
holes on the long end of the back panel. Attach
other side panel to back and secure with nuts.
(See Figure 2)
Figure 2
PAGE 2 OF 9
ASSEMBLY
4. Attach top panel to side and back panels using six
M6 x 16 mm bolts and nuts. (See Figure 3) Tighten
bolts along the back panel only. Leave the bolts
towards the front of the cabinet loose.
5. Insert slotted shelf into the cabinet, starting at top,
and bolt to the side panels using four M6 x 30 mm
bolts. Tighten the back two bolts only. (See Figure 3)
NOTE: Front bolts should remain loose to allow
easy installation of other shelves.
NOTE: For cabinets with more than one shelf,
continue to repeat step six until all shelves are
installed.
Figure 3
6. Attach the bottom panel to the back and side
panels using six M6 x 16 mm bolts and six nuts.
(See Figure 4) Tighten all bolts used to connect the
bottom panel.
Figure 4
7. Stand cabinet upright.
8. Tighten all remaining bolts.
0721 IH-7009