Uline H-7011 Manual Del Usuario página 2

NOTE: Two person assembly required.
NOTE: Do not tighten bolts until instructed.
NOTE: Bolt heads should face towards the
outside of the cabinet for added security.
1. Place one side panel on the ground with the flat
side down. (See Figure 1)
2. Attach back panel to side panel using four bolts
and nuts. (See Figure 1)
NOTE: Back panel should be positioned behind
side panel.
Figure 1
3. Rotate locker on its back and place four bolts
through the holes on the long end of the back
panel. Attach other side panel to back and secure
with nuts. (See Figure 2)
Figure 2
PAGE 2 OF 9
ASSEMBLY
4. Attach top panel to side and back panels using six
nuts and six bolts. (See Figure 3)
Figure 3
5. Attach the two bottom support bars to the two side
panels in the front and back using four bolts and
four nuts. (See Figure 4)
Figure 4
6. Stand locker upright.
7. Attach side ledges to the side panels using four bolts
and four nuts roughly halfway up. (See Figure 5)
a. Attach safety chain at any location along the
side ledge. (See Figure 5)
Figure 5
8. Tighten all bolts.
0721 IH-7011