Fuels/Refueling - Dolmar HT-2249 D Manual De Instrucciones

FUELS/REFUELING

Fuel and oil mirture
The engine of the hedge Trimmer is a high-efficiency two-stroke engine.
It is run with a mixture of fuel and two-stroke engine oil. The engine is
designed for unleaded regular fuel with a min. -octane value of 91 ROZ.
In case no such fuel is available, you can use fuel with a higher octane value.
This will not damage the engine, but may cause poor operating behaviour.
A similar situation will arise from the use of leaded fuel.
To obtain optimum engine operation and to protect your health and the
environment, only unleaded fuel should be used!
For lubricating the engine use a two-stroke engine oil (quality grade:TSC-3),
which is added to the fuel.
The engine has been designed for use with DOLMAR two-stroke engine oil
and a mixture ratio of 50:1 only to protect the environment. In addition, a
long service life and a reliable operation with a minumum emission of exhaust
gases is guaranteed. It is absolutely essential to observe a mixture ratio of
50:1 (DOLMAR 2-stroke engine oil), otherwise the reliable function of the
Hedge Trimmer cannot be guaranteed.
The correct mixture ratio:
Gasoline : DOLMAR genuine two-stroke engine oil = 50 : 1 or
Gasoline : Other manufacturer's two-stroke engine oil = 25 : 1
recommended
NOTE: When mixing gasoline with two-stroke engine oil, use only gasoline
which contains no ethanol or methanol (types of alcohol). This will
help to avoid possible damage to engine fuel lines and other engine
parts.
Do not mix gasoline and oil directly in the fuel tank.
NOTE: For preparing the fuel-oil mixture, first mix the entire oil quantity with
half of the fuel required. In an approved can which meets of exceeds
all local code standards, then add the remaining fuel.
Thoroughly shake the mixture before filling it into the Hedge Trimmer's
tank.
It is not wise to add more engine oil than specified to ensure safe
operation. It will only result in a higher production of combustion
residues which will pollute the environment and clog the exhaust
channel in the cylinder as well as the muffler. In addition, the fuel
consumption will rise and the performance will decrease.
Handling petroleum products
Utmost care is required when handling fuel. Fuel may contain substances
similar to solvents. Refuel either in a well ventilated area or outdoors. Do not
inhale fuel vapors, avoid any contact of fuel or oil with your skin.
If your skin comes in contact with these substances repeatedly and for an
extended period of time, it will desiccate.
Variouse skin diseases may result. In addition, allergic reactions are known to
occur.
Eyes can be irritated by contact with oil, fuel etc.
If oil, fuel, etc., comes into your eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!
All manuals and user guides at all-guides.com
Observe the Safety Instructions on page 4.
Gasoline
1000 mL (1 L)
5000 mL (5 L)
10000 mL (10 L)
50:1
20 mL
100 mL
200 mL