Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Care and Cleaning
Use a dry cloth to clean the doorbell, sensor, and push buttons.
Do not use cleaners or polishes.
Do not use any fluids on the doorbell, sensor, and push buttons.
Troubleshooting
Problem
Possible Cause
Doorbell does not
sound.
Batteries not installed
correctly.
Batteries are dead.
Doorbell is not receiving
power.
The doorbell and the
sensor or push buttons
are not synced.
Solution
Make sure batteries are installed according to the
diagram inside the sensor and push buttons.
Check the charge of the sensor and push button batter-
ies and replace if necessary.
Make sure the plug-in doorbell has power.
Sync the doorbell to the sensor or push button(s). Only
one sensor or push button may be synced at a time.
Repeat these steps for each sensor or push button.
Press and hold the button on the doorbell until the
doorbell sounds a "Beep-Beep".
Press the button on the side of the sensor or the
push button(s) within 30 seconds. The doorbell will
sound a "Beep-Beep" tone to indicate the sensor or
the push button(s) is synced.
Rotate the sensor as shown in step 4 under Installa-
tion or press the push button(s) to ensure operation.
8
Capítulos
Tabla de contenido
